English

News

May . 13, 2023 16:45 Back to list

Safety Technical Requirements For The CE Certification Hook



Human powered lifting mechanism for the hook, at 1.5 times the rated load as the test load test. The hook lifting mechanism for power driven, with 2 times the rated load as test load test. Remove the hook load test, should not have any obvious defects and increase the degree of deformation, the opening should not exceed 0.25% of the original size. The inspection should be on the hook hook, low stress area marking, including rated capacity, factory or factory, inspection marks, production number etc.. The hook hook scrapped in following cases should be scrapped:

1.When Using Hooks, The Rigging Should Be At The Center Place

of Stress, Never Hang It To The Crural Point, as below.

2.When There is Crack and Deformation, Never Weld or Heat to Mend it.

3.If Put Two Rigging To The Hook, The Angle Between The Vertical Surface and Rigging (as below)Can‘t Beyond 45 Degree, The Intersection Angle Between The Two Rigging Can‘t Beyond 90 Degree.

4.When The Abrasion Of Hook Reach 10% Of Original Size,Never Use.

  1. Instructions And Notes of The Hooks

Matters Need Attention When Using The Hook

1 . When The Corrosion and Abrasion Of Hook Body Reach 10% Of Specifiedsize, Please Scrap.

2.When You See There Is Crack By Sight Or After Detection, Please Scrap.

3.For The Hooks With Safety Lock, When The Safety Lock Loose And Not Available, Please Change The Parts.

4.If The Deformation Of Opening Reach 0.25% Of Original Size, Or Other Parts Deform, Please Scrap.

5.For The Swivel Rigging, Please Add Lubricating Oil Before Use.

 

Share
Next：

Latest news
Asset 3

Need Help?
Drop us a message using the form below.

If you are interested in our products, you can choose to leave your information here, and we will be in touch with you shortly.